/ Industrial & Engineering Instruments / Mechanical Engineering Equipments / Heat & Mass Transfer Lab /

Cross Flow Heat Exchanger With Data Logging Facili

Product Code : MTHT-125/DL

$ 0 QTY. 1

Condition New

Product Description


The apparatus consists of fabricated SS shell, inside which SS tubes are fitted. Hot water passes to one end through the tubes and exit to another end. The cold water is admitted at the one end of shell, which passes over the hot-water tubes. The tubes are arranged in the shell so that the flow of cold and hot fluid crosses each other to make it cross flow. For hot water, a recirculation type water tank is provided, fitted with heaters and Digital temperature controller. Cold water at constant headcondition is to be provided from laboratory overhead tank by the end user. Flow rates of hot and cold water are measured using Rotameters. A magnetic drive pump isused to circulate the hot water from recirculation type water tank. It has an interfacing unit designed by Engineers along with Labview software. This educational software allows/enables user to log the real time experimental data and tabulate the experimental/sample reading according to the requirement of experiment. User have a control on data logging, printing the stored data and preparing spread sheets in Excel. Flexible graph plotting facility is also available in the software.

                                         Technical Details

System Water to Water
Shell Material Stainless steel
Tube ID 9.5mm, OD 12.7mm, Length 250mm (Approx)
Water Flow Measurement  low sensor (2Nos.) one each for cold & hot fluid.
Hot Water Tank Made of Stainless steel (Insulated with ceramic wool)
Hot Water Circulation Magnetic Pump
Heaters  Nichrome wire heater (2Nos)
Control panel comprising of :

Digital Temp. Controller : PID Controller, 0-199.9°C (For Hot Water Tank)

Temperature measurement : Temperature Transmitter - 5Nos. with 4-20 mA Output.

Non Contact type. With Standard make On/Off switch, Mains Indicator etc.


  • An ENGLISH instruction manual consisting of experimental procedures, block diagram etc. will be provided along with the Apparatus.
  • The whole set-up is well designed and arranged on a rigid structure painted with industrial PU Paint.

Experimentation/Learning Objectives

The main object of the experimental setup is to study the following at various flow rates:


•Heat transfer rate

•Overall Heat Transfer Co-efficient.

Utilities Required

•Water supply: 5 LPM at 1 Bar and Floor drain.

•Electricity Supply: 1 Phase, 220 V AC, 50 Hz, 32 amp MCB with earth connection (Earth voltage should be less than 5 volts)

•Floor area of 1.5 m x 0.75 m.

•Computer System: i-3 processor with DVD Drive, Windows 7/8, MS-Office pre-loaded. One USB slot required in PC for DATA ACQUISITION CARD.

Latest Products

Interested in this AD Get in touch with Seller